Product Description

Pro-Bind 2000
Bind a book in about a minute. Your choice: Hardback or Paperback

Useing the ProBind 2000 to bind your documents is easy. Put your loose sheets into the covers which have glue embedded in the spine. The ProBind 2000 melts the glue at the perfect temperature to bind the sheets into the cover, creating either a hardback (the hardback crimper is needed to finish hardback books only) or paperback book.

The Pro-Bind 2000 is a completely new design from the old Covermate 700 you may be familiar with.
First you will notice two buttons on the Pro-Bind 2000; one button for soft covers and the second button for hard covers. The hardcover cycle will automatically adjust the time to a 60 second cycle allowing for full penetration of the heat to fully liquefy the glue in the hardcover books.

When combined with the Pro-Bind Hard Cover Crimper a perfect hardcover bind is assured every time.

Next change we made in the unit is the position of the electronics and the position of the heater. On the old Covermate 700 the heater board was flat and the circuit board was mounted under the sliding front panel. The new design of the Pro-Bind 2000 has allowed us to mount all electronics to the inside of the front of the binding unit thus keeping it from being constantly jarred and away from the heat source. In addition we have angled toward the back the entire front slide and heating plate 15 degrees. This allows you�re books to remain in a closed position while heating and you end up with a better bind.



The Pro-Bind 2000 has a 2 inch binding capacity, a 30 second soft cover cycle, and a 60 second hardcover cycle.

Both units carry a one year warranty, are all metal construction, and are made here in the United States.

Pro-Bind 2000

● All Metal Construction
● No Warm Up Required
● Auto Shut Off
● One Button Operation
● Weighs approx. 10 lbs
● 1/16" to 2" Binding Capacity
● 14.75" Binding Length
● Binds Multiple Documents At One Time
● Circuit Board Mounted on frame away from heating unit
● Cycle Time 30 seconds Soft Cover & 60 seconds for Hard Cover
● 15 Degree Angle on Heating Plate - Allows for less spreading of sheets in binding process
● Factory Set Heat - Fully electronically programmable for changes in paper material or content substraights - 300 to 350 degrees
● One year Warranty